OPERATION:
1 INSERT AC POWER PLUG INTO A 110V VOLT AC OUTLET.
2 CONNECT THE POWER CORD OF YOUR EQUIPMENT (13.5V
14.1 VDC) TO THE
OUTPUT BINDING POST TERMINALS ON THE FRONT OF THE UNIT. BE SURE
THAT POLARITY IS CORRECT THE RED POSITIVE ( + ) TERMINAL AND BLACK
NEGATIVE ( ) TERMINAL ARE MARKED. REVERSAL OF POLARITY MAY DAMAGE
YOUR EQUIPMENT
3 TURN SWITCH TO "ON”, RED LIGHT IN SWITCH WILL ILLUMINATE.
4 THE INPUT POWER IS PROTECTED BY THE FUSE WHICH IS LOCATED AT THE
REAR OF THE UNIT AND CAN BE REPLACED BY UNSCREWING THE FUSE
HOLDER IF THE FUSE IS BURNT OUT. DO NOT USE A FUSE LARGER THAN 1.5
AMPS. USE OF HEAVIER FUSE MAY RESULT IN DAMAGING TO THIS UNIT
5 THISUNITHASELECTRONICOVERLOADPROTECTIONWITHINSTANTAUTOMATIC
RESET FUNCTION IF OUTPUT IS OVERLOADED THE OUTPUT POWER WILL
AUTOMATICALLY SHUT OFF RELEASE POWER CORD OF YOUR EQUIPMENT
FROM THE OUTPUT TERMINALS AND CHECK THE ACTUAL POWER RATING OF
YOUR EQUIPMENT THIS UNIT WILL AUTOMATICALLY RESET INSTANTLY.
6 OVER TEMPERATURE PROTECTION CIRCUITRY IS USED IN PSL92X TO
PREVENT OVER HEAT DAMAGE UNIT WILL BE SHUT DOWN
MINUTES AFTER 15 MINUTES( MIN.) AT 100% RATED LOAD.
5(*8/$7('ꢁ'&
32:(5ꢁ6833/<
:,7+ꢁ&,*$5(77(ꢁ-$&.
02'(/ꢀꢁ36/ꢂꢃ;
25 MINUTES( MIN.) AT 80% RATED LOAD
7 THIS UNIT FEATURED WITH A CAR CIGARETTE JACK FOR THE CONVENIENCE
OF YOUR MULTIPLE CHOICES.
CAUTIONS:
1 DO NOT USE WITH EQUIPMENT REQUIRING MORE THAN RATING AMPS
2 DO NOT USE OUTDOORS DO NOT EXPOSE, UNIT TO RAIN. MOISTURE. WATER
OR ANY OTHER LIQUIDS
INSTRUCTION MANUAL
3
DO NOT REMOVE COVER IN ANY CASE RETURN TO DEALER FOR REPAIR IF
DAMAGED.
4 THIS UNIT HAS A SPECIAL BUILT-IN FEATURE THAT WILL SHUT THE UNIT DOWN
IF MARKED AMPERAGE IS EXCEEDED. THIS WILL AVOID BURN-OUT OF YOUR
EQUIPMENT AND OF UNIT IF UNIT DOES CONSISTENTLY SHUTDOWN. THIS
MEANS YOU ARE DRAWING TOO MUCH AMPERAGE RETURN UNIT TO PLACE
OF PURCHASE AND UPGRADE TO NEXT AVAILABLE UNIT OFFERING HIGHER
AMPERAGE. PLEASE DO NOT BYPASS OR ALTER THIS CIRCUIT AS IT IS THERE
TO PROTECT YOU. ANY ALTERATION OR MISUSE WILL VOID YOUR WARRANTY.
“DANGER”
HIGH VOLTAGE
REFER TO QUALIFIED TECHNICIAN FOR SERVICE.
4
|